Drive operations
Description
This device is designed for non-hazardous in-
door environments.Its working temperature
should be within the specified range.
These models comply with the EN 12895
standard on electromagnetic compatibility.Cor-
rect operation can no longer be guaranteed in
areas where the electromagnetic fields could
exceed the thresholds specified by the stand-
ard.
The trucks must be used on dry, clean, flat
ground.
Low-lift stackers without initial lift can go over
ramps and gentle slopes.Low-lift stackers with
initial lift can go over larger obstacles.
Loads must be homogenous, with a maximum
recommended height of 2 m.
CAUTION
Always adapt your driving to the ground conditions
(uneven surfaces, etc.), particularly hazardous work-
ing areas and the load.
CAUTION
– To prevent the bottom of the lifting system from
scraping the ground, always raise the forks half-
way up before setting off.
– Remember to turn off the power supply before
leaving the equipment.
– For effective protection, wearing safety footwear is
compulsory.
– When travelling, the mast must be tilted backward
and the load must be in the lowered position.
CAUTION
Driving safety instructions
– The driver must drive slowly around corners and
when entering narrow passageways.
– The driver must always maintain a safe braking
distance from vehicles or persons in front of him.
– The driver must avoid braking suddenly, making
U-turns too quickly and overtaking in areas with
poor visibility.
CAUTION
The working area of the truck must be adequately lit.
If the working area is not sufficiently illuminated,
working spotlights must be installed to ensure that
the driver can see properly.
Operation
4
Drive operations
50 50028011505 EN - 03/2022 - 06
To Next Page
Loading...