Still ECV 10 C - Topping up the Gear Oil

– Unscrew the oil cap(1).This oil cap has a
dipstick.
– Use a clean cloth to dry the dipstick.
– Reinstall the oil cap, then remove it again
and check whether the traces of oil on the
dipstick are between the maximum and
minimum marks.
NOTE
You can lift again after you have finished add-
ing the oil. You must continue checking the
hydraulic oil level if there is still a banging
noise.
– Reinstall the disassembled parts in reverse
order.
NOTE
Only use hydraulic oil that meets the specifica-
tions.Refer to "Lubricants".
Topping up the gear oil
CAUTION
Do not add gear oil that contains impurities.


Maintenance
5
Maintenance work
7950028011505 EN - 03/2022 - 06