Still ECV 10 C - Putting the Equipment Back into Operation

NOTE
The battery must be charged every month to
avoid depletion of the battery through self-dis-
charge, as the sulfation would destroy the bat-
tery.
Putting the equipment back into operation
– Thoroughly clean the truck.
– Lubricate the equipment according to the lu-
brication and servicing requirements.
– Clean the battery, apply specialised grease
to the electrode studs, and install and fix the
terminals on the battery.
– Charge the battery.
– Check whether the hydraulic oil contains
condensation water.Change the hydraulic
oil according to requirements.
– Put the equipment back into use.
If there are difficulties with operating electrical
system switches, you should apply contact
spray to the exposed contact surfaces and re-
move the oxide layers on the surfaces of the
operating component contacts by performing
repeated switch operations.After putting the
equipment into operation, the driver should im-
mediately perform repeated brake perform-
ance tests.
Operation
4
Putting the equipment back into operation
6550028011505 EN - 03/2022 - 06