Brake
NOTE
The braking performance of the equipment de-
pends very much on the condition of the floor
surface.This should be taken into considera-
tion when driving.
NOTE
The driver must drive carefully and cautious-
ly.When there is no danger, the driver must
use moderate braking to avoid the load mov-
ing or the trailer becoming detached.
Braking can be done in the following ways:
●
Emergency stop brake
●
Automatic braking
●
Regenerative braking
●
Reverse braking
Emergency stop brake
– Press the emergency off switch (2); the
equipment power supply will be cut off.
Automatic braking
– Releasing the tiller (1) will initiate forced
braking.
Slackening the tiller (1) will cause it to move to
the braking area (B). Alternatively, lowering
the tiller to the brake area (B) at the bottom
will also initiate forced braking.
CAUTION
If the tiller moves slowly into the brake position, iden-
tify the cause and rectify the fault.
If necessary, replace the gas spring!
Regenerative braking
– Release the drive switch. The drive switch
will automatically return to the initial position
and the vehicle will begin to enter the re-
generative braking state. When it deceler-
ates to <1 km/h, the electromagnetic brake
will bring the motor to a stop.
Operation
4
Drive operations
5350028011505 EN - 03/2022 - 06
To Next Page