CAUTION
Do not touch nearby loads or loads positioned at the
side or in front of the load being handled.
Arrange the loads with a small space between them
to prevent them coming into contact with one anoth-
er.
Picking up a load from the ground
– Approach goods carefully when driving the
vehicle.
– Lower the forks so that they can easily be
inserted into the pallet.
– Insert the forks below the pallet.
– If the goods are shorter than the forks,
move the goods a few centimetres from the
end of the forks so as not to scratch the
goods in front.
– Lift the goods a few centimetres.
Carrying a load
DANGER
Personnel must not stand under or near the truck
when the load is in the raised position.
DANGER
Never transport a load with the forks in the raised
position as the equipment may become unstable.
– Always drive forwards for optimum visibility.
– When carrying a load on a slope, always
climb and descend with the load uphill.Nev-
er travel diagonally across the slope or
make a U-turn.
– Reverse gear must only be used for depos-
iting a load.Since visibility in this direction is
restricted, you should only travel at very low
speed.
– Never drive with an unstable load.
– If visibility is poor, let someone guide you.
– Be careful of low passageways, low door-
ways, scaffolding, pipes etc.
Operation
4
Hydraulic operations
60 50028011505 EN - 03/2022 - 06
To Next Page
Loading...