8
1800 898 750
service@wkfe.com.hk
Telephone:
Email:
Getting Started Cont.
Your robot vacuum cleaner is equipped with many practical functions that
allow it to clean wooden floors, short-pile carpet, tiles and vinyl flooring.
The device uses artificial intelligence (AI) to adjust to its environment and
reliably clean its working area. The device is equipped with three level
sensors that recognise staircases and other dips to ensure that it will not
fall.
The robot vacuum cleaner works in 4 cleaning stages: random, spiral, along
the wall and spiral again. After the forth stage the vacuum cleaner will
restart from the beginning with its random programme.
Turn on the power switch at the right side of the robot. The LCD
display will begin to flash. (See Fig 1).
Before you first use your robot vacuum charge the battery overnight for 12
hours. It is also recommended that the battery is flat before you recharge for
the first 2 or 3 times. Alternatively, if the battery is very low the robot
vacuum will automatically return to the docking station to charge. Do not
use again until the full charge has completed.
Cleaning System
The brushes on the sides of the device sweep dust and dirt towards the
suction opening. Subsequently, the dirt particles are sucked into the dust
container. The filter ensures that dirt particles remain on the floor of the dust
container so that only clean air is expelled from the device.
The dust container element of the device consists of the dust container,
filter and dust container cover. The element can be removed without any
tools.
Please refer to the Cleaning and Care sections in this manual.
Figure 1
To Next Page
Loading...
