For first time use, make sure the battery has been fully charged for 12 hours
for best performance.
Normal charge time will take within 4-5 hours before the battery is full again.
Getting Started
7
1800 898 750
service@wkfe.com.hk
Telephone:
Email:
Setting the Remote Control
***The following steps are very important, or the remote control may fail.
You should check the code of the remote control and vacuum so that they can
function together.
1. Check that the remote control and cleaner have enough power, turn off the
cleaner, press OK on the remote control for more than 4 seconds, and then
turn on the vacuum without releasing OK. After the cleaner beeps twice,
release OK, then the code check set is finished.
2. If you fail to hear a beep during the code check, just repeat the above
process.
To Next Page
Loading...
