18
1800 898 750
service@wkfe.com.hk
Telephone:
Email:
1. Open the battery cover and insert 2 x “D” batteries (not included) into the battery compartment.
2. The Space Isolator should generally be placed near the entrance to a room or area where you
do not want the vacuum to enter.
3. Remove any obstacles from the area in front of the Space Isolator as much as possible.
4. Use the toggle switch to set the distance of signal: Low/3m & High/6m.
5. Turn off the toggle switch when not in use to save the battery.
Installation Method of the Space Isolator
1. The Space Isolator should be placed at the same level as the ground where the
vacuum is running.
2. You should check whether the vacuum can pass the Space Isolator before use.
3. The distance between the Space Isolator and the docking station should be more
than 3m or there will be interference.
4. The battery consumption is related to the selected transmitting distance and
working duration. Please select proper transmitting distance and low transmitting
power to save the battery. Don’t forget to turn off the toggle switch while not in use.
Instructions Cont.
To Next Page
Loading...
