8 Communication with Apple Devices
To accept connections from Apple devices the service record of the BlueMod+B20
contains an Apple specific UUID. This UUID is implemented in the standard Serial Port
Profile (1101) service record of the BlueMod+B20.
To connect to an Apple device, the user shall connect to the service named “Wireless
iAP” of the Apple device. The ATD command has to be used with the corresponding
service channel number. Use the BSRV command to find the channel number of the
service named “Wireless iAP”.
To make the BlueMod+B20 visible to Apple devices the Class of Device (S302) has to
be set to a value listed in the table below:
To Next Page
Loading...