Installation Instructions
Step 2: Connect
to
the electricity
supply
We
recommend that the appliance is
connected
by
a qualified electrician,
who
is a member
of
the N.I.C.E.I.C.
and
who
will
comply with the I.E.E.
and local
r~gulations.
Important:
Ensure that you route a
II
mains electrical cables well clear
of
any aqjacent heat source, such as an
oven
or
grill.
Warning:
This appliance must be
earthed.
1.
Where
a fixed connection is used,
a device
allowing
the appliance
to be isolated on all poles from
the mains supply with a contact
opening width
of
at least 3mm
must
be provided.
Use
a
13
amp
fuse.
2. A type
HOS
V
V-F
cable must be
used as the mains lead.
The
cross
section must be 2.Smm
2
•
3. The mains terminal
block
is
positioned at the right hand rear
of
the
top
service panel.
S.
Connect the cable to the terminal
block, and tighten the cable clamp.
6. Close the terminal box, ensuring
that the cover
is
engaged on the
locking tabs.
26
To Next Page
Loading...
