Installation Instructions
Step
1:
Prepare
installation
Do
not
lift
the
oven
by
the
door
handle.
Whilst
every care
is
taken
to
eliminate
burrs and
raw
edges from
this
appliance,
please take care when handling -
we
recommend . the use
of
protective
gloves during installation.
Please note that the
weight
of
this
appliance
is
approximately
27kg
(unpacked) . Take care when lifting it
into the housing
unit - always
use
an
appropriate
method
of
lifting.
If
this
appliance
is
to
be installed near
to a corner where the adjacent cabinets
run
at
right angles
forward
of
the
appliance, there must be a
gap
of
at
least 90mm between the appliance and
the cabinets,
to
prevent overheating
of
the cabinets.
Note:
When
removing the appliance
from the base
tray
packaging care
should be taken not
to
damage
the
appliance.
1.
When
installing in a
typical
600mm
deep, built in housing
unit, the false back should
be
removed from the housi ng
un
it
to
provide the necessary depth for
installation.
2.
When
the false back
is
removed, it
is
normally the case that the support
shelf for the appliance leaves a
gap
between the back edge and
the
wall
of
approximately 80mm.
3. If
no
gap
occurs between the back
edge
of
the shelf and the
wall
Qehind the unit,
we
recommend
that a
gap
of
at
least
30mm
is
made
by
shortening the shelf.
Front
ofov~
~.
co
(])
Cl::::
12mm~"""'''''''''''''''''
~
...
Remove the fixing screws from the
gap
~
t3~~O
polythene
bag
on
the
top
of
the
Back
edge
of
support shelf
appliance, but leave the
appliance
in
the base
tray
packaging
until you are
ready to install it.
24
To Next Page
Loading...
