All switches with CE marking, other approvals are possible, see marking on the type plate or in the attached
document:
CSA Canada GOST-R Russia
CCC China TAT Approval on request
4.2 Dimensional drawing
NOTE
Stromag would like to emphasise that users should refer to the dimensional drawing for all technical
details, including: dimensions, weights, tolerances, tightening torques, and any other technical specifi-
cations and units required for assembly, such as securing equipment and lubricants.
Should this information be necessary during assembly, a reference will be made in the dimensional
drawing at the respective point in this documentation.
A dimensional drawing is supplied as a separate document and can be requested additionally from
Stromag Customer Care. For this, the same product data is required as when ordering spare parts.
4.3
Marking on the product
The following data can be found on the housing of the GTES:
Manufacturer's address, order number, designation, month/year of construction, marking, voltage U
i
, current I
th.
NOTE
Switches and housings have identical type plates. The data, for e.g. for a spare part order, must be
read from the respective assembly group.
18
Mounting/operating instructions Gear limit switch Type series HGE • No. 152-00000 F • 10/2017
To Next Page
Loading...
Need help?
General
