7.3.1 Operating conditions
See section 4.1.
7.4 Recommissioning
No specific measures are necessary for recommissioning.
7.5 Decommissioning
7.5.1 Temporary decommissioning
No specific measures are necessary for temporary decommissioning.
7.5.2 Final decommissioning
No specific measures are necessary for final decommissioning.
Dispose of materials according to local regulations.
8 Maintenance and inspections
8.1 Special safety guidelines
CAUTION
Risk of accidents due to non-observance of the safety guidelines
There is a risk of accidents if the general safety guidelines are not observed.
► All safety guidelines must be observed, see section 2.
8.2 Measures for environmental protection
RECYCLING
Dispose of components as well as auxiliary and operating materials according to the local guidelines
in a correct and environmentally-friendly way.
8.3
General points
The GTES switching points are checked as part of a performance check of the machine.
NOTE
When using the GTES in hoists, proceed according to the applicable guidelines and standards for the
entire machine.
8.4 Maintenance and inspection intervals
In principle, no maintenance work or inspections are necessary for the GTES.
38
Mounting/operating instructions Gear limit switch Type series HGE • No. 152-00000 F • 10/2017
To Next Page
Loading...
Need help?
General
