Strong SRT 2402 - 4 First Installation; First Installation of Android; First Installation of DTV

4.0 FIRST INSTALLATION
This procedure will enable you to enjoy and set up your Android receiver in just a few steps. It is
recommended to follow the First Installation step by step. It will guide you through the basic installation
and channel searching process.
4.1 First installation of Android
Step 1: Language Select your preferred language for the on-screen menu. Use tu to
change language and press OK to conrm your selection.
Step 2: Resolution Select the screen resolution you prefer. Default selection is
Automatic, which already shows the best setting of the connected
screen. Press OK to conrm your selection. A banner appears to
conrm the new setting by selecting OK. Conrm again with OK. If
you do not see this banner immediately, wait a couple of seconds
and the screen will return to its previous state. Then try another
resolution.
Step 3: Screen Adjust Use pq to adjust the size of the screen so it exactly ts the screen
you are using. Press OK to conrm.
Step 4: Network If you have already connected the Ethernet cable to your router,
in most cases the unit nds the correct settings automatically and
jumps directly to Step 5. If you haven’t connected a Ethernet cable,
but prefer using Wi-Fi, select Wi-Fi and press OK to open the menu
with the available Wi-Fi networks. Use pq to select your network
and enter the key or password. The 0 ~ 9 buttons on the remote
control can also be used for entering.
Step 5: Date&Time: If you have successfully connected to the Internet in Step 4, this
screen will automatically show the date and your local time. If
necessary, you can select an item to modify it manually.
Step 6: Final step: Select Scan TV channel if you would like to proceed directly to install
Digital TV from satellite, terrestrial or cable signals. Select Login in to
Google to set up a Google account. Select Go to Home page to skip
the steps above and go directly to the Android main page.
4.2 First Installation of DTV
This menu allows you to install your Free-To–Air TV and radio channels from one of the three tuners.
Step 1: Dene DTV scan options
Aspect Ratio: Select Full for the ocial size or Auto to adjust the size with your
screen.
Zap Mode: Choose Black Screen to get a black screen when zapping through the
channels. Select Hold Screen to hold the last watched screen when
zapping through the channels.
Subtitle Mode: Select O, Normal or Hard of Hearing to dene how you would like to
display subtitles.
LCN: Select On if you would like to use LCN modes in DVB-T.
Tuner Type: Select which tuners you would like to use: Satellite and Terrestrial or
Satellite and Cable
9
English