1 remote control
2x batteries (AAA type)
HDMI cable
Power adapter (12 V 2 A, max. 24 W)
WARNING: The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
NOTE: For the appropriate usage with this device, use only power adapters as
listed below (in case of a necessary exchange):
Model: ASM-1202000;Manufacturer:Shenzhen Aosimai Technology Co.Ltd
The usage of other power adapters may cause damage to the device. Such damage is not covered under
warranty.
1.4 Usage of external USB devices
It is recommended to use USB 3.0 storage devices for records or playback of UHD /4K. If your
device is not compatible to USB 3.0 specications, recording, playback and other multimedia
functions of the receiver might not work properly.
The Timeshift of programmes in Ultra HD is not guaranteed with the currently available USB
devices.
STRONG cannot guarantee compatibility with all types of USB devices such as web cams,
keyboards, mouse devices, storage devices.
STRONG cannot guarantee perfect operation when a HDD and a web cam are used at the same
time.
If you are going to use external USB HDDs (Hard Disk Drives), please consider that power
specications may exceed the supported output of your receiver (max. 5 V/500 mA). If so, please
connect your USB HDD to an external power adapter.
It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss
of information.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 1234
2.2 Front Panel
Fig. 1
1. LED indicator: Blue LED in operation, red LED in standby mode.
2. IR sensor: Receives IR signal from the remote control.
3. USB: To connect USB devices like: mouse/keyboard/storage devices
5
English
To Next Page
Loading...
