Strong SRT 2402 - Network; Display; Sounds; Apps

6.1 Network
In this menu you can change or setup the connection to the Internet by Wi-Fi or LAN (RJ45 cable) as
explained in point 5.1 Enter and store your passwords and/or gateway ports here.
6.2 Display
Here you can set your {Screen resolution}, {Screen position}, HDR to SDR} and {SDR to HDR}
6.2.1 Screen resolution
In this menu you can select your preferred HDMI output resolution, which is supported by the connected
TV. The AUTO mode automatically selects the best output resolution of the combination (so called
‘handshake’). Select Screen position if the size of your display is too large or too small for the connected
screen. Select Daydream to set up a time when the screen shall be switched o or set up a time to switch
o the receiver when it is not used for a period of time.
6.2.2 Screen position
Select {Screen position} if the size of the displayed screen is a bit too large or too small for the connected
screen.
6.2.3 HDR to SDR
In this menu you have the option to set up HDR (High Dynamic Range) image to SDR (Standard Dynamic
Range) quality.
6.2.4 SDR to HDR
In this menu you have the option to set up SDR (Standard Dynamic Range) image to HDR (High Dynamic
Range) quality.
6.3 Sounds
In this menu you can setup the correct audio output setting if you like to use Dolby audio to connect to
a digital amplier.
6.3.1 System sounds:
Select On to hear every time a click of remote buttons as conrmation. Select O for no click sound.
6.3.2 Surround sound:
Selection Auto automatically transmits Surround sound if available. Always selects Surround sound
always to ON and option Never switches surround sound OFF.
6.3.3 Other sound settings:
The selection HDMI sends Dolby audio. The selection PCM gives only Stereo to all outputs.
6.4 Apps:
In this menu you will nd installed applications and you will be able to remove these apps.
15
English