EasyManuals Logo

Strong SRT 40FB4003 User Manual

Strong SRT 40FB4003
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Problem Possible cause and solution
Playback of video is
causing picture freeze/
macro blocks or similar
distortion, especially on HD
content.
Read/write speed of your USB device could be too low. Make sure to use
a USB storage device with sufficient speed and space. Pen drives (USB
sticks) may not support sufficient speed.
No signal or weak signal,
intermittent reception.
a) Cables might have loosened; moisture might have entered into
cables or connectors, heavy rain at present or heavy storm at
present.
Check the cable connections, LNB and other equipment
connected between the LNB and the receiver, or peak the dish.
Wait for rain/storm to subside. Ask a local satellite specialist for
advice.
b) The satellite dish is not pointing at the (correct) satellite(s).
Adjust the dish. Ask a local satellite specialist for advice.
c) Satellite dish is too small, trees or buildings in path.
Change to a larger dish or change position of dish.
d) Signal is too strong, dish is oversized.
Connect a signal attenuator to the LNB input. Ask a local satellite
specialist for advice.
Bad picture/blocking error
during heavy rain.
Heavy rain will attenuate satellite signals, below a certain level blocking
will occur.
Make sure your dish installation is up to standards to minimize rain
effects. When in doubt, ask a local satellite specialist for advice.
NOTE: If the problem persists after these solutions, please contact your local
support centre or send a support mail via our website www.strong.tv.
8.0 SPECIFICATIONS
Audio
Audio Output: 8 W + 8 W
Video
Channel coverage: DVB-T2: 174 MHz-230 MHz; 470 MHz-860 MHz
DVB-C: 50-858 MHz
DVB-S2: 950 MHz-2150 MHz
System: DTV: DVB-T2, DVB-S2, DVB-C
ATV: PAL/SECAM (BG/DK/1)
AV: PAL, NTSC
Connectors 32 inch
1x ANT/CABLE IN
1x SAT IN
1x CI+
1x AUDIO L/R IN
1x VIDEO IN
2x HDMI
18

Other manuals for Strong SRT 40FB4003

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Strong SRT 40FB4003 and is the answer not in the manual?

Strong SRT 40FB4003 Specifications

General IconGeneral
Screen shapeFlat
Response time8.5 ms
Display diagonal40 \
Display brightness250 cd/m²
Display technologyLED
Native refresh rate60 Hz
Contrast ratio (typical)5000:1
Display diagonal (metric)101 cm
Screen format adjustments16:9
Motion interpolation technologyIQR (Image Quality Ratio) 100 Hz
3DNo
Battery typeAAA
Stand weight100 g
Tuner typeDigital
Analog signal format systemNot supported
Digital signal format systemDVB-C, DVB-CI+, DVB-S2, DVB-T2
Operating system installed-
RMS rated power- W
Product colorBlack
Panel mounting interface200 x 200 mm
RF connector typeF, IEC
USB 2.0 ports quantity1
S-Video inputs quantity0
Power consumption (max)74 W
Power consumption (standby)0.5 W
Power consumption (typical)54 W
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)225 mm
Height (with stand)526 mm
Weight (with stand)3600 g
Depth (without stand)63.9 mm
Width (without stand)901 mm
Height (without stand)511.3 mm
Weight (without stand)3500 g

Related product manuals