8
PART 1 • English
start scan. After Channels are found, they will be stored and receiver switches to the
first one saved in the list.
5.2.3 Antenna Setting
1. Press MENU to enter main menu.
2. Use the qp buttons to select Installation, press OK to enter the menu.
3. With the qp buttons select Antenna setting and press OK to enter.
4. Press the tu buttons to change setting. If On is selected, the receiver will provide 5V
antenna power (for active antennas).
5. Press EXIT button to exit.
5.2.4 LCN Mode
If LCN (Logical Channel Numbering) is activated and LCN signal is provided by operator, then
channels will be stored at operator defined order. You can activate/deactivate the LCN function by
setting the "LCN Mode" to ON/OFF.
5.3 Setup
This menu allows you to set OSD Language, Subtitles preference, TV System, Region and Time, Timer
Setting, OSD Setting and Parental Lock.
1. Press pq buttons to highlight desired menu and press OK button to enter the
setting menus. Then press pq buttons to select desired item. Settings can be
changed by pressing tu buttons. You can get better overview if press OK first. Now
you can select desired setting by pq buttons and confirm it with OK.
2. Press EXIT button to exit.
5.3.1 OSD Language
This menu allows you to set OSD Language.
5.3.2 Subtitles preference
This menu allows you to set preferred Subtitles Language and select Subtitles Type between Normal
and Hard of Hearing.
5.3.3 TV System
This menu allows to setup different settings concerning your TV set.
Display Mode: PAL/NTSC/AUTO
Aspect Ratio: Use this menu to configure the screen aspect between: 4:3PS (Pan&Scan),
4:3LB (Letter Box), 16:9 (Wide Screen), and AUTO.
Video Output: Use this menu to switch the video output mode either to RGB or to CVBS
5.3.4 Region and Time
Here you can set your region and time zone.
Region: This menu is used for changing the region setting.
GMT Usage: This menu is used for usage of GMT.
The options are: Off / User Define / By Region
To Next Page
Loading...
