12
PART 1 • English
Selected by number
Enter the channel number directly by pressing numeric buttons, and press the OK button to select
desired channel.
Selected by on-screen channels list
You can also select the required channel directly from on-screen channel list. This is displayed using
the receiver’s main menu. See chapter 5.1.1 TV Channel list in this manual for operation detail.
Alternatively you can call up channel list by pressing OK in viewing mode.
Selected by EPG
You can also select the required channel directly from electronic programme guide (EPG).
This is displayed by pressing EPG button on remote control. See in the below chapter of this manual
for operation detail.
6.2 Accessing the Electronic Program Guide (EPG)
1. Press EPG button to enter EPG menu.
2. Press numeric button [2] to switch between channel list, events schedule of the
selected channel and now/next events.
3. In the event schedule, press numeric button [3] to book the selected event, press OK
to open the Detail menu for the selected event.
4. Press numeric button [1] to open the Booking list menu.
6.3 Accessing the favourite channels
1. Press FAV button to enter favorite group menu.
2. Press p or q cursor buttons to select the desired favourite group.
3. Press OK button to enter the favorite channels list, and press pq buttons to select
the favourite channel.
7.0 TROUBLE SHOOTING
There may be various reasons for the abnormal operation of the receiver. Check the receiver according
to the procedures shown below. If the receiver does not work properly after checking it, please contact
your local Serviceline or STRONG dealer. Alternatively you can send a support mail via our website:
www.strong.tv. Do NOT open the receiver cover. It may cause a dangerous situation and the warranty
will get void.
Problem Possible cause What to do
LED indicator not lit Mains lead unplugged Check mains lead
No signal found Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to switch
ON antenna power/external feed
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna Power
ON/ connect external feed
No picture or sound
on TV
Scart/ AV is not selected on your TV
TV is not switched on
Switch to correct TV input
Switch TV on
To Next Page
Loading...
