27
No response to remote control The receiver is off. Plug in and turn on the plug.
The handset is not aimed
correctly.
Aim the handset at the IR
sensor.
The IR sensor is obstructed. Check for obstructions.
The handset batteries are
exhausted.
Replace the handset batteries.
Password forgotten The default password is 0000 Contact the local Service
Hotline or send an email to our
support via www.strong.tv
The external USB HDD does
not start.
The power consumption is
too high.
Connect an extra power supply
adapter to your USB HDD
device.
The receiver switches to
standby automatically.
The Auto Standby function is
activated and has reached the
set time (default 3h).
Set the power down time or
disable it in the System Auto
Standby menu .
9.0 SPECIFICATIONS
Demodulator
Demodulation: QPSK, 8PSK
Input symbol rate: DVB-S QPSK: 1 ~ 45 Ms/s
DVB-S2 8PSK/QPSK: 10~30 Ms/s
FEC decoder: Auto, 1/2, 2/3, 3/4, 5/6, 7/8 in DVB-S mode
1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 in DVB-S2 mode
3/5, 2/3, 3/4, 5/6, 8/9, 9/10 in 8PSK mode
Video Decoder
Profile level: MPEG-2 MP@ML, MP@HL, MPEG-4 H.264/AVC
Input rate: Max. 20 Mbit/s
Aspect ratio: 16:9 widescreen, Pillarbox, 4:3 Pan&Scan, Letterbox
Video resolution: PAL 50Hz: 576i, 576p, 720p, 1080i, 1080p
NTSC 60Hz: 480i, 480p, 720p, 1080i,1080p
Audio Decoder
Audio decoding: MPEG-1 Layer 1 & 2, AC3, Dolby Digital Down mix, PCM
Audio mode: Mono L/R, Stereo, E-AC3, Dolby Digital, Dolby Digital Plus*
Sampling rate: 32, 44.1, 48 kHz
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
Tuner
Type1: F Type, IEC169-24, Female
Input frequency range: 950 – 2150 MHz
RF impedance: 75 Ohm unbalanced
To Next Page
Loading...
