25
and tu to Record. If needed, the parameters for the timer can be changed as well. Press p/q, tu
and use 09 to do so. From the EPG channel list view you can open the Book list with the INFO button,
which allows you to open a list of all booked timers.
Programming a timer via the Timer menu
If you want to programme a timer via the timer menu, press the BLUE button to open it. Now the
timer list is displayed. The list is empty if no bookings have been made previously. Press RED to Add
a new timer and congure your timer as explained above. For further details about this menu, please
refer to chapter 7.4.1 Timer (Schedule) in the user manual.
7.7.4.4 Playback
After a recording has been made you will nd the new folder HBDVR created on your external USB
storage device. By pressing the u button in viewing mode you can access this folder directly. Inside
the folder HBDVR the following functions are supported:
OK Starts playback in preview mode.
RED Starts playback in full screen mode.
9 Accesses the parent folder/directory.
YELLOW Marks a recording for deletion. When all recordings you want to delete are
marked, press OK. A message will appear to conrm deleting. By pressing
OK again the recordings will be permanently deleted from your external USB
storage device. Press if you don’t want to delete them.
GREEN Opens the keyboard for entering a new name for a selected recording. In the
keyboard, press p/q tu for navigation, to enter a character press OK. After
nishing your changes, select OK and press the OK button to save the new
name. If you want to discard your changes select Cancel and then press OK.
BLUE Allows you to enter the time to start playback. To enter the desired time use
09 and press OK to start the playback at this time.
*This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via USB has
not yet been installed.
7.7.4.5 DVR Congure*
Find technical details about your USB device, like Partitions, Timeshiftsize, Total space and Free space.
7.7.4.6 Format*
WARNING The format function will delete all data and information from your USB
device or selected partition. STRONG will not take any responsibility for
damaged or lost data on the USB device.
If you have multiple partitions on your storage device, select the partition you would like to format
and press OK to continue. An attention banner will now be displayed. Press OK to start formatting (or
to cancel it). The format procedure will take some time, depending on the size of the used storage
device. At the end of the process, the “Formatting is complete” message will appear. Press to exit
the menu.
To Next Page
Loading...
