27
Password forgotten The default password is 0000 Contact the local Service Hotline
or send an email to our support via
www.strong.tv
The external USB HDD
does not start.
The power consumption is too
high.
Connect an extra power supply
adapter to your USB HDD device.
The receiver
switches to standby
automatically.
The Auto Standby function is
activated and has reached the set
time (default 3h).
Set the power down time or
disable it in the System Auto
Standby menu .
9.0 SPECIFICATIONS
Demodulator
Demodulation: QPSK, 8PSK
Input symbol rate: DVB-S QPSK: 1 ~ 45 Ms/s
DVB-S2 8PSK/QPSK: 10~30 Ms/s
FEC decoder: Auto, 1/2, 2/3, 3/4, 5/6, 7/8 in DVB-S mode
1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 in DVB-S2 mode
3/5, 2/3, 3/4, 5/6, 8/9, 9/10 in 8PSK mode
Video Decoder
Input rate: Max. 20 Mbit/s
Aspect ratio: 16:9 widescreen, Pillarbox, 4:3 Pan&Scan, Letterbox
Video resolution: PAL 50Hz: 576i, 576p, 720p, 1080i, 1080p
NTSC 60Hz: 480i, 480p, 720p, 1080i,1080p
Audio Decoder
Audio decoding: MPEG-1 Layer 1 & 2, AC3, Dolby Digital Down mix, PCM
Audio mode: Mono L/R, Stereo,
Audio Support: E-AC3, Dolby Digital, Dolby Digital Plus*
Sampling rate: 32, 44.1, 48 kHz
*Dolby Digital, Dolby Digital Plus and the double-D symbol are registered trademarks of Dolby Laboratories
Tuner
Type1: F Type, IEC169-24, Female
Input frequency range: 950 – 2150 MHz
RF impedance: 75 Ohm unbalanced
Signal level: -65 to -25 dBm
LNB power: 13/18 V DC (+/- 5%), max. 0.5 A, overload protected
Switch versions: DiSEqC 1.0, 1.1
LNB options: Universal, SatCR (max. 8 users)
Motor drive options: DiSEqC 1.2, GotoX (DiSEqC 1.3)
System & Memory
Main processor: MSTAR MSD7S01
To Next Page
Loading...
