22
NEVER open or disassemble your receiver. This may cause a dangerous situation and will void the
warranty.
Symptom Cause Remedy
The standby indicator
does not light up
The mains lead is unplugged/the
multipoint connector is switched off.
Check the mains lead/switch the
multipoint connector on.
There is no image, no
sound, no display
There is no power supply Check the connection cables
There is a short circuit in coaxial
cable
Disconnect device from mains power
supply, eliminate the short circuit
in the coaxial cable or connections,
reconnect, and activate device
Cables are missing or defective. Check your connecting cables
A wrong video format was selected
in the OSD settings
Check the settings to make sure your
TV supports the selected format
There are small blocks in
the video, occasionally
no sound, occasionally
no signal
The signal is too weak Check for defective cables or
connectors. Alternatively, reduce the
coaxial cable length
Scrambled channel
message
The channel is scrambled. Select an alternative channel.
No response to remote
control
The receiver is off. Plug in and turn on the plug.
The handset is not aimed correctly. Aim the handset at the IR sensor.
The IR sensor is obstructed. Check for obstructions.
The handset batteries are
exhausted.
Replace the handset batteries.
Password forgotten The default password is 0000 Contact the local Service Hotline
or send an email to our support via
www.strong.tv
The external USB HDD
does not start.
The power consumption is too
high.
Connect an extra power supply
adapter to your USB HDD device.
The receiver switches to
standby automatically.
The Auto Standby function is
activated and has reached the set
time (default 3 hours).
Set the power down time or disable
it in the SettingsTime Setting menu,
parameter Auto Standby After.
9.0 SPECIFICATIONS
Demodulator
Demodulation: QPSK, 8PSK
Input symbol rate: DVB-S QPSK: 1 ~ 45 Ms/s
DVB-S2 8PSK/QPSK: 1 ~ 45 Ms/s
FEC decoder: Auto, 1/2, 2/3, 3/4, 5/6, 7/8 in DVB-S mode
1/4, 1/3, 2/5, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 in DVB-S2 QPSK mode
3/5, 2/3, 3/4, 5/6, 8/9, 9/10 in DVB-S2 8PSK mode
Video
Profile level: MPEG-2 MP@ML, MPEG-4 AVC high profile H.264 HP@L4.1/MP@L4.1
Max. video resolution: 1920x1080p
Aspect ratio: 4:3 and 16:9, Pan & Scan Automatic adjustment for 16:9 TV sets,
Letterbox supported
To Next Page
Loading...
