Stryker SERFAS - Indications for Use; Contraindications; Warnings & Cautions; Warning

HANDPIECE CABLE/PROBE
Align connection features
SET UP AND INTERCONNECT SECTION
Connect
9
1. Connect either end of the Handpiece Cable to the probe connector on the front panel of Generator.
2. Connect the other end of the Handpiece Cable to the Probe as shown.
3. When proper connection is achieved on both ends of the Handpiece Cable, the probe indicator above the
connector will illuminate, the CUT Level will default to a level appropriate for the probe used, and the COAG level
will default to MED. Refer to the SERFAS Probe User Insert and Appendix B of this manual for definition of CUT/
COAG Levels.