COAG MODE:
1. There are three levels available in the COAG Mode: HIGH, MED, and LOW. COAG Level will default to MED
following proper connection of the Probe. Power settings for the COAG Mode are dependent on probe type used
(refer to the Probe Family Definition table located in the SERFAS Probe User Insert).
2. COAG Level can be adjusted by pressing either the HIGH, MED, or LOW button on the front panel of the
Generator. A beep will sound when a different COAG Level is selected or the synthesized voice will announce
COAG Level.
3. Activation of the COAG Mode can be achieved by pressing the blue pedal on the Footswitch, or by pressing the
blue button on the Probe, if available (NOTE: some models of the Probe do not have hand-control capabilities).
4. When COAG Mode is activated, the blue COAG Indicator will illuminate and a pitched tone (lower than the CUT
tone) will sound continuously for the duration of the activation.
NOTE: Avoid pressing two buttons or pedals simultaneously. If this occurs, an error alarm will sound, the red
triangle indicator on the front panel will illuminate, and an error code will be displayed in the CUT Level
window. To return to normal mode of operation, press a single pedal or button. A list of error definitions can
be found on the Pull-out Tray underneath the Generator or in the Error Codes and Troubleshooting section of this
manual.
VV
VV
V
OLOL
OLOL
OL
UME UME
UME UME
UME
ADJUSTMENTADJUSTMENT
ADJUSTMENTADJUSTMENT
ADJUSTMENT
::
::
:
Volume of tones and voice feedback can be adjusted by using the Speaker Volume Control knob located on the back
panel of the Generator.
TT
TT
T
ONE/VONE/V
ONE/VONE/V
ONE/V
OICE SELECTION:OICE SELECTION:
OICE SELECTION:OICE SELECTION:
OICE SELECTION:
The user has the option to select the type of audio feedback preferred. Either tone or voice feedback is available
with SERFAS. To select between the two, use the Tone/Voice Selector located on the back panel of the Generator.
INSTRUCTIONS FOR USE
11
To Next Page
Loading...
