ERROR CODES & TROUBLESHOOTING GUIDE
NOTE: If disturbance occurs on the video monitor or any other electronic instrument, the user should:
● Ensure that Handpiece Cable is not near any other instrument cables.
● Ensure that Endoscope has a non-metallic coupling ring (i.e. Stryker CE Mark Endoscopes).
NOTE: If errors (F1-F9) persist, refer to the Service and Claims section of this manual to obtain repair service.
NON-RECOVERABLE ERRORS & CORRESPONDING CODES
Error Code Reason for error Solutions
F1
F2
RF Current measurement error
Hardware shutdown (current, voltage, or power limits
exceeded)
RF generation/measurement error during
power-on test
CPU Configuration error
Software error
Illegal CPU Instruction
RAM error
ROM CRC error
COP Timeout error
F7
F9
F8
F6
F5
F4
F3
Cycle power to the unit (turn unit off
and then on)
Same as above
Same as above
Same as above
Same as above
Same as above
Same as above
Same as above
Same as above
18
To Next Page
Loading...
