LANGUAGE SELECTION INSTRUCTIONS FOR SYNTHESIZED VOICE FEATURE
The user may select an alternative language for voice feedback from the selection available. The language selec-
tion process should occur during the system self-test (when system is turned ON using the Mains Power Switch).
To select a language:
1. Press any two of the three “COAG” buttons located on the front panel simultaneously during the system
self-test.
2. Use the Up/Down Cut Level arrows located on the front panel to cycle through languages.
3. Press any one of the three “COAG” buttons to select a language. Language chosen will be announced.
APPENDIX C
29
To Next Page
Loading...
