Strymon CONDUIT User Manual

Conduit - MIDI Hub
pg 10
Connections – MIDI Distribution for a Pedalboard
The most common use for Conduit is for distributing MIDI messages
from a MIDI controller to pedals that are connected via 1/4" cables
(included) and 5-pin DIN MIDI cables (not included).
Follow the steps below when using Conduit to distribute MIDI
messages from a MIDI controller connected to the DIN MIDI IN.
Connect a power supply (not included) that provides 9V DC center-
negative power and at least 50mA of current to the 9VDC power
input. When Conduit powers up, the LEDs will light up to show
that the device is powered. The color of the four ACTIVITY LEDs
will show the current TRS Jack configuration.
(See page 7 for details on output configurations.)
1
9VDC
MIDI OUT MIDI IN
USB
SET
NOTE: For non-Strymon pedals the corresponding TRS jack may
need to be configured.
(See page 8 for details.)

Strymon CONDUIT Specifications

General

Brand	Strymon
Model	CONDUIT
Category	Switch
Language	English