Strymon CONDUIT User Manual

Conduit - MIDI Hub
pg 12
NOTE: When Conduit is not connected to a computer via USB, all
MIDI data received at the 1/4" jacks from the pedals will be merged
and sent to the 5-pin DIN MIDI port.
Connect one of the included 1/4" TRS cables to one of the 1/4" I/O
jacks on Conduit. Connect the other end to the 1/4" MIDI control
input on your pedal. On compatible Strymon pedals, connect to
the EXP or MIDI jack set to MIDI mode.
(See your pedal’s user manual for detailed instructions.)
Configure the connected pedal to communicate on the desired
MIDI channel. All MIDI channels are broadcast to all outputs.
(See your pedal’s user manual for detailed instructions.)
If the connected pedal has the ability to send MIDI OUT, you may
want to set this to off unless bi-directional communication is
desired.
(See your pedal’s user manual for detailed instructions.)
3
4
5
Connections – MIDI Distribution for a Pedalboard (cont.)

Strymon CONDUIT Specifications

General

Brand	Strymon
Model	CONDUIT
Category	Switch
Language	English