Strymon Iridium - Configuring Iridium to Use MIDI; MIDI Connectivity and Setup

IRIDIUM - Amp & IR Cab
pg 23
Configuring Iridium to Use MIDI
Using MIDI unlocks a set of tools that can be used to load any of
Iridium’s 300 preset locations and automate knob changes using a
suitable MIDI controller or interface connected to Iridium’s EXP jack.
This requires a MIDI controller/interface with at least one quarter-inch
output or a Strymon MIDI EXP cable.
Check strymon.net/support/iridium for a list of compatible devices.
STEREO
MONO
IN OUT L OUT R EXP
SUM
USB
EXP
STEREO
MONO
IN OUT L OUT R EXP
SUM
USB
EXP
OR
MIDI Enabled Stompbox
MIDI Controller with
5-pin MIDI Outputs
MIDI Controller with
1/4” TRS Output
MIDI 1/4”
TRS Interface
MIDI EXP cable TRS cable
OR