to “ON”.
NOTE
If the power does not switch even
though the above procedure was fol-
lowed precisely, contact your SUBARU
dealer.
& Starting engine
1. Apply the parking brake.
2. Shift the select lever into the “P”
position.
3. Depress the brake pedal.
4. Hold the access key with the buttons
facing you, and touch the push-button
ignition switch with it.
When the communi cation between the
access key and the vehicle is completed,
a chime (ding) will sound. At the same
time, the push-button ignition switch turns
to the “Acc” or “ON” position.
5. Within 5 seconds after the push-button
ignition switch turns to the “Acc” or “ON”
position, while depressing the brake ped-
al, press the push-button ignition switch.
NOTE
If the engine does not start even
though the above procedure was fol-
lowed precisely, contact your SUBARU
dealer.
Trunk lid (Legacy) – if the
trunk lid cannot be opened
NOTE
If you open the trunk lid with a key
while the alarm system is armed, the
alarm system is triggered and the
vehicle’s horn sounds. In this case,
perform any of the following opera-
tions.
. Press any button on the remote
transmitter.
. Insert the key into the ignition
switch and turn the ignition switch to
the “ON” position.
For details about the alarm system,
refer to “Alarm system” F2-25.
The trunk lid can also be opened using the
key.
In case of emergency 9-21
– CONTINUED –
To Next Page
Loading...
