2. Wrap a flat-head screwdriver with vinyl
tape or a cloth, and insert it in the gap (A)
to remove the cover.
3. Remove the board in the cover (B).
Place it with the battery side facing
upward.
4. Wrap a flat-head screwdriver with
insulating tape, and insert it between the
battery and the board (B). Take out the
battery as shown in the figure.
5. Insert a new battery with its positive (+)
side facing upward as shown in the figure.
Attach the cover firmly.
Maintenance and service 11-55
– CONTINUED –
To Next Page
Loading...
