Subaru 2013 Outback - Head Restraint Adjustment; Seat Heater (if Equipped)

1. Turn the ignition switch to the “ON”
position.
2. While the select lever is in the “P”
position and the parking brake is applied,
press button “1” or “2”.
3. The chirp sound sounds and the seat
moves to the registered position.
4. When the seat moves to the registered
position, the chirp sound sounds.
NOTE
. If a new position is registered for the
same button, the previously registered
seat position is deleted.
. If the vehicle battery is removed, the
registered seat position is not deleted.
. When the button “1” or “2” is
pressed within 45 seconds after the
driver’s door is opened, the registered
seat position can be retrieved even if
the ignition switch is in the “LOCK” or
“OFF” position.
! Retrieval of the seat position regis-
tered with access key
1. Hold the registered access key.
2. Unlock the driver’s door by pressing
the “
” button or gripping the door
handle.
3. Open the driver’s door.
4. The chirp sound sounds and the seat
moves to the registered position.
5. When the seat moves to the registered
position, the chirp sound sounds.
NOTE
. If the registered seat position cannot
be retrieved after performing the pre-
vious procedures, try the following
procedures.
(1) Press the “SET” button on the
driver’s door.
(2) Press the “
” button on the
access key or the door lock button
to lock the doors.
(3) Perform the prior procedures
again.
. If the keyless access function is
disabled, the seat position cannot be
retrieved by gripping the driver’s door
handle. However, the seat position can
still be retrieved by pressing the “
”
button on the access key. For informa-
tion about how to enable/disable the
keyless access function, refer to “Dis-
abling keyless access function” F2-17.
. If a new position is registered for the
same access key, the previously regis-
tered seat position is deleted.
! Clearing the registered seat position
with access key
1. Close the driver ’s door.
2. While holding the access key and
pressing the “SET” button, press the “
”
button on the access key.
Seat, seatbelt and SRS airbags 1-7
– CONTINUED –
Information Provided by: