38
Vehicle Dynamics and Driver Assist Systems
May 2017
Clutch Sensor Calibration and Engagement Position Setting Modes
After the clutch has been replaced, the relationship of the new clutch engagement point and
the release of the Hill Holder must be established. Navigate through the SSMIII and select
“Clutch Engagement Position Setting”. Slowly release the clutch pedal while having the SSMIII
data monitored. The numerical value that appears in the lower scale must be entered into the
upper scale. This will establish the release point of the EPB during Hill Holder operation.
To allow for a slightly advanced release of the EPB use a Higher number.
SSMIII Clutch Sensor Calibration Mode SSMIII Clutch Engagement Position Setting
Note: After replacing the Clutch Stroke Sensor select Clutch Sensor Calibration Mode.
The EPB Control Unit will automatically perform this process. Then select clutch engagement
position setting and enter the engagement position value. If the EPB control module assembly
is replaced, the “Brake” warning light on the Combination Meter will flash until the Force Sensor
Calibration and Clutch Sensor Calibration (if applicable) modes are performed.
2-23
To Next Page
Loading...
