Sullair LS-12 - Page 53

Section 7
ILLUSTRATIONS AND PARTS LIST
48
7.8 COMPRESSOR COOLING AND LUBRICATION SYSTEM (WATER---COOLED, LS---12 SERIES 40 AND
50HP)
key part
number description number quantity
1 elbow, tube---m 1” x 1” 810516---100 3
2 tube, 1” 250032---112 1
3 connector, tube 1” 810216---100 1
4valve,fluidstop
(I)
016741 1
5 elbow, tube---m 1/4” x 1/4” 810504---025 1
6 tube, 1/4” 841015---004 3 ft.
7 nipple, pipe xs 1” x close 822216---000 1
8 elbow, tube---m 5/16” x 1/4” 810505---012 1
9 connector, tube 1 1/4” x 1 1/4” 810220---125 2
10 bushing, reducing 1 1/4” x 1 802105---040 1
11 filter, fluid
(II)
250025---522 1
12 connector, tube 1/4” 810204---025 2
13 nipple, pipe 1 1/2” x close 822224---000 3
14 elbow, reducing 1 1/2” x 1 1/4” 801606---050 1
15 connector, tube---m 1 1/2” x 1 1/2” 810224---150 5
16 tube, 1 1/2” 250018---400 1
17 plug, pipe 1/2” 807800---020 3
18 valve, globe 1/2” 041007 1
19 nipple, pipe 1/2” x 4” 822108---040 1
20 tee, reducing 1 1/2” x 1/2” x 1 1/2” 802206---026 2
21 tube, 1 1/4” 250018---246 1
22 elbow, tube---m 1 1/2” x 1 1/2” 810524---150 3
23 tube, 1 1/2” 250018---401 1
24 bushing, reducing 2” x 1 1/2” 802108---060 1
25 union, pipe 3/4” 802515---030 1
26 separator/trap
(III)
040847 1
27 coupling, reducing 2” x 1 1/2” 801016---012 1
28 tube, 1 1/2” 250018---252 1
29 bracket, air connector and condenser drain 250017---233 1
30 washer, springlock 1/2” 837508---125 8
31 capscrew, hex 1/2”---13 x 1 1/2” gr5 828608---150 8
32 bushing, reducing 3/4” x 1/2” 802103---020 1
33 elbow, tube---el 3/8” mnpt x 3/8” t 813706---375 2
(Continued on page 51)
(I)
For maintenance on fluid stop valve no. 016741, order repair kit no. 001684.
(II)
For maintenance on fluid filter no. 250025---522, order repair kit no. 250025---526.
(III)
For maintenance on separator/trap no. 040847, order separator kit no. 044374.
PLEASE NOTE: WHEN ORDERING PARTS, ALWAYS INDICATE SERIAL NUMBER OF COMPRESSOR.