Sumitomo Cyclo BBB4 - Flange Mount (Banjo) Type Torque Arm

20 Operation & Maintenance Manual
Cyclo® BBB4
Cyclo® BBB4
Torque Arm Installation, continued
FlangeMount(Banjo)TypeTorqueArm
1
2
4
3
Torque Arm
Bracket
Bracket
Mounting
Bolts(s)
Item Number Description
1 Torque Arm Bracket
2 Bracket Hardware
3 Rubber Bushing (qty 3)
4 Washer (qty 2)
Table11.FlangeMount(Banjo)Type
Torque Arm Components
Sumitomo Supplied Components of
FlangeMount(Banjo)TypeTorqueArm
FlangeMount(Banjo)TypeTorqueArm
Installation Procedure
1
Attach the Flange Mount (Banjo) Torque Arm Bracket to the Cyclo® BBB4 using
mounting hardware.
Bracket
Bolt Size
[1]
Torque
lb•ft (N•m)
4A 8 x M10 34 – 38 (46 – 51)
4B 8 x M12 59 – 65 (80 – 88)
4C 8 x M16 152 – 167 (206 – 227)
4D,4E 8 x M20 290 – 319 (392 – 431)
4F 8 x M24 507 – 558 (686 – 755)
Table12.FlangeMount(Banjo)TorqueArmBoltTightening
Note: [1] Bolt class equal to ISO/JIS Class 8.8
Torques
Unit Size
When installed,
bolt must be
parallel to this
surface
Rubber
Bushing
Washer
Torque Arm Bolt
(Customer
Supplied)
2
Place washer and rubber bushing on bolt.
Insert torque arm bolt (supplied by customer) through mounting tab on Banjo
torque arm.
Make sure bolt is parallel to Flange Mount (Banjo) Type Torque Arm surface
when fully installed.