Cyclo® Portion Disassembly/Assembly, continued
Disassembly Procedure
Cyclo® Reduction
Components
Remove all bolts
Slow Speed
Rollers
Snap Ring
Ball Bearing
Spacer
4
While continuing to externally support the entire Cyclo® BBB4 unit, remove each of
the bolts from the Cyclo® ring gear housing (shown in horizontal position for clarity).
5
Carefully separate the bevel gear housing assembly from the Cyclo® portion
to gain access to the Cyclo® reduction components.
6
Remove the slow speed rollers. Additionally, check the pins on the pin carrier to
see if any of the rollers have adhered to them.
7
Remove the snap ring, the ball bearing and the spacer from the high speed shaft.
58 Operation & Maintenance Manual
Cyclo® BBB4
To Next Page
Loading...
