F Series Manual
5
Danger area around the head
The head with the modules and about 20 cm around it can be considered as the extra danger
area during module/tool installation. When the operator is working within this area, he has to
be extra careful. When a module or a tool needs to be changed, the operator is obliged to
perform certain actions within the danger area around the head. So the operator must be sure
that the machine will not make any unexpected movement while performing the changes. There
are only two possible ways to be sure the machine will not make any sudden movements: either
changing the module/tool while the machine is switched off, or following the module/tool
change procedure.
WARNING: When changing a module or a tool, always make sure that Axis Control
is initiated and check whether the second button in Axis Control is If it is
, then click it, so the machine comes offline and will not move anymore.
To Next Page
Loading...
