8. !! IMPORTANT !!
9.
10. If the unit is assembled, then do following test :
11. cutting dept test :
12. Load the widest vinyl available.
13. Set the knife depth critical on the right side
14. Check the knife over the full width of the machine, check for irregularity in
15. cutting dept - be critical.
16. If not in order reset the top beam and base plate or call for help
17. tracking test :
18. Do a couple of tracking test (preferably over 6m or more) to ensure the
tracking
19. quality
20. If it fails the test then following action might be taken :
21. Check the sleeves for dirt
22. Check the brake on the roller guiding
23. Try switching the camrollers
24. Try and set the rear backscrews in the camrollerassy the same as the one
you might
25. have removed.
26. Measure the pressure each camroller has and change if necesarry
Left Plate Removal A-3
To Next Page
Loading...
