Transmission Oil Filling
1.
Fill transmission oil from dipstick plug (1) opening to the
maximum level mark on the dipstick.
2.
Put the gearshift lever in neutral and start the engine. Let it run
on idle until the oil reaches a temperature over 77 °F [25 °C].
3.
Fully tighten the dipstick check that the transmission oil
reaches the required level mark on the dipstick.
4. If required, fill up to the correct level.
NOTE : Let the oil stabilize before checking its level.
IMPORTANT: See the lubricants and fuel chart for the
type of oil to be used according to the transmission type.
NOTE : If implement used requires more quantity of oil,
make sure that the transmission contains enough oil for
every work condition. Top off as required.
1
Max mark
Filling point located on rear side of the transmission.
Refer below table for appropriate oil viscosity according to
the ambient temperature.
We recommend use of ISO VG-32 oil grade for transmission.
Recommended Oil Grade-
Ambient
Temp. (°F)
Oil
Temp.(°F)
Oil Grade
VG 32 -50~80.6 37.4~158
VG 56 32~96.8 50~176
To Next Page
Loading...
