Summit TX25H - Hydraulic, Brake, and Electrical Issues

clogged
Low
Contact dealer for how to adjust it correctly servicing
Adjust relief valve according to specification
Incorrect hydraulic pressure
Hydraulic strainer clogged
Mechanical linkage might be faulty
Hydraulic strainer clogged
Check and top up
en
en
* TPL = Three Point Linkage
Linkage not connected properly
Brakes only work when fully pressed
authorized servicing dealer
authorized servicing dealer
Excessive fuel
consumption
Excessive heating
of oil
Oil level is high or less
Check and maintain proper level
Clean or replace
Linkage goes down
slowly
Bush tight
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Contact your authorized servicing dealer
Linkage not lift fully
Response valve setting improper
Improper lift arm setting
Improper internal adjustment
TPL not respond to
lifting while
operating hydraulic
lever
Heavy load on linkage
Hydraulic system not
working properly
Response valve setting very low
Oil level low
Hydraulic system faulty
Clean or replace
Hydraulic pump not working
Noise while applying
brakes in one side
Wrong adjustment of brake pedal
Brakes only works
when fully pressed
Wrong adjustment of brakes
Check and adjust
Check and adjust
Check and adjust
Electrical system
not working
Startet motor not
working
Battery not charging