76 Sun StorageTek 2500 Series Array Hardware Installation Guide • March 2007
To connect a terminal to the serial port of a controller:
1. Connect the 6-pin mini-DIN connector of the serial cable to the serial port
connector (diagnostic port) on the controller (
FIGURE 1-3 on page 6).
2. Connect the RJ-45 connector of the serial cable to the serial port connector on
the terminal. It may be necessary to use an RJ45-DB9 adapter between the
serial cable RJ-45 connector and the serial port of the terminal.
3. For PC and laptop serial connections, you will also need to use a null modem.
Connect the null modem between the serial cable or RJ45-DB9 adapter and the
PC serial port.
Note – If your PC does not have a serial port, you can use a USB–Serial Port adapter
(separately available from third-party vendors; not included with 2500 Series Array
ship kits).
Serial Cable Pinouts
TABLE 6-1 shows the pinouts for the RJ45-DIN serial cable (Sun part number 530-
3544) included with the 2500 Series Array shipkit.
▼ To Set Up the Terminal Emulation Program
To set up a terminal emulation program to connect to the serial port:
1. Select VT100 emulation.
2. Remove any modem strings from the connection profile.
3. Set up the connection profile with the following communication settings:
TABLE 6-1 RJ45 to DIN Serial Cable Pinouts
RJ45 ----------> PS2-miniDin
1Tx 6Rx
2
3Rx 1Rx
4,5,7 3, 5 GRD
6Rx 2Tx
84
To Next Page
Loading...
Need help?
General
