Sun Microsystems StorageTek 2500 Series User Manual

78 Sun StorageTek 2500 Series Array Hardware Installation Guide • March 2007
▼ To Configure the IP Addresses
The serial port Service Interface menu enables you to set up the IP address
configuration for the Ethernet port on the controller.
To set up the IP address configuration for the Ethernet port on each controller:
1. Select option 2, Change IP Configuration:
2. Specify that you do not want dynamic IP addressing, using a DHCP server,
used for this port:
The current or default IP configuration for the selected Ethernet port is displayed.
3. Enter the static IP address and, optionally, a subnet mask for the Ethernet port:
Note – If you are not using DHCP IP addressing and have a gateway IP address on
your subnet, you must also specify a gateway IP address for the Ethernet port. This
option displays only if the serial interface detects a gateway.
Service Interface Main Menu
==============================
1) Display IP Configuration
2) Change IP Configuration
3) Reset Storage Array (SYMbol) Password
Q) Quit Menu
Enter Selection:
Service Interface Main Menu
==============================
1) Display IP Configuration
2) Change IP Configuration
3) Reset Storage Array (SYMbol) Password
Q) Quit Menu
Enter Selection: 2
Configure using DHCP ? (Y/N): n

Sun Microsystems StorageTek 2500 Series Specifications

General

Brand	Sun Microsystems
Model	StorageTek 2500 Series
Category	Speaker System
Language	English