shownetwork(8)
System Administration 409
â– In the M8000/M9000 servers and when the takeover IP address has been
disabled by setnetwork(8) command, nothing will be displayed even though
the takeover IP address is specified by the shownetwork(8) command.
â– The setnetwork(8) command configures a network interface used by the XSCF.
EXAMPLES
EXAMPLE 1 Displays the information for XSCF-LAN#0 on XSCF unit 0.
EXAMPLE 2 Displays the information for XSCF-LAN#1 on XSCF unit 0 in the M3000/
M4000/M5000 server.
EXAMPLE 3 Displays the information for ISN on the XSCF unit 0.
XSCF> shownetwork xscf#0-lan#1
xscf#0-lan#1
Link encap:Ethernet HWaddr 00:00:00:12:34:56
inet addr:192.168.10.11 Bcast: 192.168.10.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:54424 errors:0 dropped:0 overruns:0 frame:0
TX packets:14369 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20241827 (19.3 MiB) TX bytes:2089769 (1.9 MiB)
Base address:0x1000
XSCF> shownetwork lan#1
xscf#0-lan#1
Link encap:Ethernet HWaddr 00:00:00:12:34:56
inet addr:192.168.10.11 Bcast: 192.168.10.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:54424 errors:0 dropped:0 overruns:0 frame:0
TX packets:14369 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20241827 (19.3 MiB) TX bytes:2089769 (1.9 MiB)
Base address:0x1000
XSCF> shownetwork xscf#0-if
xscf#0-if
Link encap:Ethernet HWaddr 00:00:00:12:34:56
To Next Page
Loading...
Need help?
General
