deleteboard(8)
34 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised August 2009
OPTIONS The following options are supported.
OPERANDS The following operand is supported:
-c disconnect Detaches the XSB from the domain configuration and keeps it
assigned. If the -c option is omitted, "-c disconnect" is used.
-c reset Reserves disconnect of an XSB. If the -c option is omitted, "-c
disconnect" is used.
-c unassign Disconnects the XSB completely from the domain configuration
and puts it in the system board pool. If the -c option is omitted,
"-c disconnect" is used.
-f Forcibly detaches the specified XSB.
Caution – If the -f option is used to forcibly add a system
board to a domain, all the added hardware resources may not
work normally. For this reason, use of the -f option is not
recommended in normal operation. If the -f option must be
specified, verify the status of every added system board and
device.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-n Automatically answers "n" (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
-v Displays a detailed message. If this option is specified with the
-q option, the -v option is ignored.
-y Automatically answers "y" (yes) to all prompts.
xsb Specifies the XSB number to be disconnected. Multiple xsb
operands are permitted, separated by spaces. The following xsb
form is accepted:
x–y
where:
x An integer from 00–15.
y An integer from 0–3.
To Next Page
Loading...
Need help?
General
