6
2 Open printer paper cover and place roll of thermal paper, edge down, in
cover. Printing surface is on inside of roll.
3 Turn on power, then push edge of paper into inlet slot at bottom of paper
holder until auto-loader catches paper and feeds about 10 cm through paper
cutter. If necessary, keep pressing paper FEED button until paper feeds
straight and smoothly.
Low Printer Battery Indication
When POWER (green) indicator starts flashing once every 0.5 seconds and
printer goes OFF LINE (red indicator), connect AC adapter.
If any data is in the memory buffer when POWER indicator starts flashing,
connect the AC adapter as quickly as possible to prevent data loss, then push ON
LINE button.
Set Up Software
Prerequisites
• Ensure the computer meets the system requirements in Recommended
System Requirements on page 35.
• Administrative rights may be required to install and use the software, and to
set up communication between the computer and the Radon Monitor.
Install Software
1 Download the 1027 Radon Monitor software from the Radon Support
website, https://support.sunnuclear.com/radon/ and save it to you r c omputer
or laptop.
2 Run the executable file, Radon1027_v<X>.exe and follow the on-screen
instructions to install the software.
Radon 1027 icon appears on the desktop.
Set Up Communication
Model 1027 ships with an RS-232 cable (P/N 801032(Z)) that connects to a
computer’s serial (COM) port. This connection allows data transfer from Model
1027 to a computer, where you can view, edit, and print reports.
Newer computers have USB ports instead of serial ports. In this case, an optional
“USB to Serial Adapter” cable is used to connect Model 1027 to the computer. A
typical adapter has a short cable with a serial connector on one end, a USB
connector on the other end, and a small circuit board molded to the connector.
Note: When paper is loaded correctly, red OFF LINE indicator stops
flashing and stays on to indicate printer is still in OFF LINE mode.
To Next Page
Loading...
