38
Important: The Descaling Cycle
can be exited at any point by
pressing the MANUAL BREW
BUTTON.
Step 1. Descaling Cycle of Group Handle
and steam wand
- Turn the DIAL to the STEAM position.
- The STEAM LIGHT will
now be fully illuminated.
- The Pump will start and hot water will
run from the Group Head & Steam Wand.
Over a pre-defined period the Pump will
make different noises.
- When hot water has stopped being
released from the Group Head & Steam
Wand, this step is finished.
- To indicate the machine has finished this
step the machine will beep, the STEAM
LIGHT will now start to flash.
- Turn the DIAL to the vertical position, and
the Steam light will extinguish.
- The Descale icon will
continue to pulse.
Move to Step 2.
Step 2. Descaling Cycle of Hot water tap
Turn the DIAL to the HOT WATER position.
- The HOT WATER LIGHT will now be fully
illuminated.
- The Pump will start and hot water will
run from the Hot Water tap. Over a
pre-defined period the Pump will make
different noises.
- When hot water has stopped being
released from the Hot water tap, this step
is finished.
- To indicate the machine has finished
this step the machine will beep, the HOT
WATER LIGHT will now start to flash.
- Turn the DIAL to the vertical position, and
the hot water light will extinguish
- The Descale icon
will continue to pulse.
Move to Step 3.
Step 3. Preparing for Purge
Important: There is a maximum of 5
minutes allowed to complete this step
before the Descaling Cycle will exit.
- The Steam Wand & Group Head now need
to be purged clean with fresh water to
remove descaling solution.
• Rinse Water Reservoir
Remove the Water Reservoir and rinse
thoroughly under running water, ensuring
that all traces of the descaling solution.
• Fill Water Reservoir
- Fill the Water Reservoir to the ‘Max’ line
with cold water and insert into position.
• Empty Containers
- Empty water from the containers and
replace.
Move to Step 4.
Step 4. Start Purge
- Turn the DIAL to the STEAM position.
Descaling cycle – Espresso machine