To Next Page

To Previous Page

7 Web Main Interface User Manual

AI Port Input Type Lower Limit Upper Limit

AI3 Current(mA) 4 20

AI4 Current(mA) 4 20

step 3 Optional: If there is an external IO device connected to the Logger, click External to set the AI

information of this device.

- - End

7.9.11.4 DI

step 1 Click System > Port Parameter > DI to enter the Built-in page.

step 2 Set Initial Status to NO or NC. Click to apply the changes.

step 3 Optional: If there is an external IO device connected to the Data Logger, click External to set the

DI parameters of this device.

- - End

7.9.11.5 DO

step 1 Click System > Port Parameter > DO to enter the Built-in page.

step 2 Set Initial Status to NO or NC, and click to set Function, Action Mode, and Pulse

Duration. Click to save the settings.

step 3 Optional: If there is an external IO device connected to the Data Logger, click External and set

the DO parameters of this device.

- - End

7.9.12 MPLC

7.9.12.1 MPLC (Broadband PLC)

step 1 Click System > MPLC to enter the corresponding page.

step 2 Click on the operation bar to set the master and slave MPLC nodes.

step 3 Set the master node, and the following parameters should be set.

table 7-8 Parameters description

Parameters Description

Band Num Support Band1~Band3

Sungrow Logger4000 User Manual

Questions and Answers: