the wi
ring, function, etc.
4 The input of charger power must be installed over current thermistor.
Do not replace it by any non professional personnel.
5 Do not detach the charger. There is high voltage inside the charger.
Non-professionals are strictly prohibited to open the shell!
6 Users should remove the dust of the charger shell at least half a year.
2 Inst
ruction
1)Matc
h for the charger with AC power grid and the battery pack
Match
for the charger and AC power grid: Before using the charger, please
make sure AC power grid voltage and its frequency are in the range
specified.
Match for the charger and battery pack: There is applied battery
specification in the "Basic Parameters" label on the charger side. Please
confirm whether battery type (flooded lead-acid batteries, sealed
maintenance-free batteries, lithium batteries, nickel-metal hydride batteries,
nickel-cadmium battery, etc.), the battery capacity (AH) and battery pack
rated voltage (V) match those on the "Basic Parameters" label. If they do
not match, it is likely to cause undercharge or overcharge, even results in
To Next Page
Loading...
