SunStar Fortuna 5 Series - Installation Procedures; Motor Mounting

4
INSTALLATION
1) Mounting your Servo Motor on the table
(D Make sure that the holes are bored on the table as shown in the
figure.
L
Table
3-0 9 Hole
MlCabte^tde
BeHHcle
® Insert three motor-fbcing bolts through the thiee holes on the table. Attach the motor base padded with vibration-ptoof rubber, and slide
flat and spring washers over the bolt stems, and then fasten the bolts with nuts. \
Motv-FDdng Bolts
Table Motor-Fodng Bo(ts(3ea)
Vibn^Ptoofnifaber
Flatvy^
SpringWaser =}=
NutofD
a
Motor-Fixing Bo!ts(3ea)
mp
Controller Box
® Make sure that the center of motor pulley is matched to diat of die sewing machine before tightening the motor-fixing bolts and nuts.
11
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com